Invasive Weed Solutions

For complete control of invasive weed species.

Garlon Ultra Fact Sheet
Garlon Ultra

For the control of a wide range of deep-rooted PERENNIAL, HERBACEOUS WEEDS and WOODY WEEDS on AMENITY GRASSLAND to include non-crop land such as motorway and railway embankments, roadsides and industrial areas.

• It contain Aminopyralid and Triclopyr.
- This combination provides excellent control of woody and invasive weeds.
- Contains 12g/l Aminopyralid (present as 23.08 g/l Aminopyralid triispropanolammonium salt)
and 120 g/l Triclopyr (present as 167.36 g/l Triclopyr triethylammonium)

• Can be used through a hydraulic tractor or quad mounted boom sprayer

• It can also be applied through a hand held application equipment
- one of the few products with a label fully cleared for this type of use.

• Fast acting - rainfast in just one hour

• Controls a wide spectrum of weeds

• It moves through the roots ensuring high levels of long term control

Maximise Success with Garlon Ultra

Peel open the label and read before use

• Use through a knapsack or boom applicator
• Choose the correct rate of application from chart below depending of target weeds
• For optimum results spray weeds whilst actively growing and before they flower,
• Not all weeds will be at the best growth stage for spraying at the time of application, so a follow-up treatment may be necessary
• Spray weeds till they are thoroughly wet, but stop before the spray runs off the leaves
• Always direct spray away from water
• Other people and pets should keep out of treated areas until the spray has dried on treated foliage (approx. 2 hours)

Bramble

Bramble

Broom

Broom

Buddleia

Buddleia

Gorse

Gorse

Japanese Knotweed

Japanese Knotweed

Common Mugworth

Commom Mugworth

Nettle

Nettle

Creeping Thistle

Creeping Thistle

Hogweed

Hogweed

Herbaceous weed control

BROADCAST Application

Weeds controlled, rates of use and timing of application

Application rates
Woody and Herbaceous weed control

LOCALISED SPOT Application

Weeds controlled, rates of use and timing of application

Application rates - Woody and herbaceous weed control
Application Notes:

BROADCAST Application

GARLON ULTRA should be applied through a tractor-mounted hydraulic sprayer provided it is in good working order and has been calibrated according to the manufacturers’ recommendations.

Mixing: Fill the spray tank half full with water and add the required amount of GARLON ULTRA mixing well. Top up with water and continue agitation until the spray tank is full. Maintain agitation while spraying. Use the spray immediately.

Spray Volume: For overall application GARLON ULTRA should be used in a spray volume between 300L and 600L per hectare to give good coverage of the weeds. Higher water volumes are recommended where weed densities are high.

Spray Quality: Apply as a MEDIUM quality spray as defined by the BCPC system.


Spot Treatment

For localised treatment using a suitable lance from a knapsack or tractor mounted sprayer, use a solution of 150-200 mL of GARLON ULTRA depending on the target weed, per 10 litres of water. Woody weeds should be thoroughly wetted with the spray solution, but spraying until "run-off" will decrease activity. The use of flood jets is recommended to prevent drift. Care should be taken to avoid local overdosing. Woody weeds should not exceed 1 metre in height.  For larger plants may need repeat applications.


Use herbicides safely. Always read the label and product information before use.